Find a repair centre

Support & Downloads: EB-2247U

How do I upgrade the firmware on the Network Interface Panel?

RELATES TO:


  • WorkForce DS-5500N, DS-6500N, DS-7500N, DS-50000N, DS-60000N, DS-70000N
  • How to upgrade the firmware for your scanner's Network Interface Panel (B12B808411)

TABLE OF CONTENTS:

EXPLANATION:


Preparation
  1. Install the Network Interface Panel on the scanner.

  2. Ensure you have installed the scanner driver on your computer.

  3. Connect the Network Interface Panel direct to your computer using an Ethernet cable.


Note:

For further information on installing the Network Interface Panel, please refer to the Network Interface Panel User's Guide


Upgrading the firmware
  1. Click here to download the latest firmware file. Run the firmware file.

  2. Click Next.


  3. Click I agree and then Next.


  4. Click Next.


  5. Check the current firmware version.

    1. Make sure the scanner appears under Model Name.

      If the scanner does not appear, ensure the network cable is connected and then click the Refresh button.


    2. Right-click on the scanner model and click on Software Information.


    3. Confirm the current firmware version of the Network Interface Panel as shown below:


  6. Click Start.


    Caution:

    Do not disconnect or turn the scanner or PC off while the firmware upgrade is in progress. Neither EPSON nor its affiliates will assume any responsibility for any damages that result from a firmware update. Your use of these instructions and the related tasks (firmware download, then firmware installation) is at your own risk.


  7. Wait while the firmware is updating.


  8. When the firmware update is complete, click Finish.


  9. Check that the firmware version has changed to the latest version, refer to Check the current firmware version for advice on checking this.

Back to Top

Did you find this article helpful

Thanks for leaving feedback